DIY Manual SMT Pick And Place Tool For $20
People Who Liked This Video Also Liked
Did this video help you?
|
F_Think OFFICIAL: Verry skill ABRAHÁM KPOVÓC: mucho bla, bla, bla ... Merv Tims: Genius!! Even the Stencil tutorial. Have you tried re flow on two sides of a board? ctcoop: Bravo , vad ca merge bine ! Felicitari ! Tot inainte ! Ron Thompson: I bought a Smd suction tool it come with different suction cups,the tool was around a dollar,doesn't work that well for me,if I was you I would buy it for the suction cups and the removeable bent needle the come with it,I like your idea. With the pump but I think those. Parts that came with my smd suction tool could improve your setup.I got it on eBay Alperen Akküncü: great :D Asad Kamal: Nice idea sir thanks. Lost Night: esti din Statele Unite? MrFlesknava: Nice work! Simply Embedded: Great video, Sir. Would that syringe work down to 0402? Any pointers on where you got it? Neut: thanks for sharing mate Adam Humphreys: Pretty sweet! Also, there are momentary power foot switches out there too, (switches only and ones with outlets). F. Lee Erickson: Can you describe how to access and reverse the valve? It seams that the chamber it is in is plastic welded or glued. Photos would help. flavio p: muito bom parabens .good . simon beliveau: Great video. Where did you get the syringe tip? For the syringe itself, I guess it can be bought at a drugstore? Daniel Scob: QUIERO TODAS ESTAS EXPLICACIONES TRADUCIDAS EN ESPANOl Si es pocibl xmenxwk: My solder paste started shiny at 140 degree C. And the final result looked like hand soldered. Maybe because my stencil was thick ? its 0.25mm. But I got it done. Thank you very much for the video. Tony Philipsson: A real pick and place don't have to cost $30K, TM220 is around $3K and the 3rd generation TM245P is $5.5K, see my video of it in action here youtu.be/90_p_KvwefQ Philip Hart: This is really inspiring. Many thanks for sharing, Orwa Diraneyya: You're a star. Honestly. |
DIY manual SMT pick and place tool for $20
5
out of 5
