James Kiffel: Hey i know you did this video a few years ago but i noticed something wrong with the video. a real good look at the AMX in the background?
Robert Meyer: I recently added a grease fitting to the auger gear box in my MTD. works good and helps to apply grease to those gears. Only took 15-20 minutes. Anyone else tried this? I apply grease to the gears in the belly of the beast as well. Anyone else have ideas on keeping the gears greased up?
Alex Bentley: It is easier to do it by turning the snowblower upside down and removing the bottom cover. You probably took 2 hours to do it when it can be done in 20.
Jeff Reynolds: Good instruction! Live north of Boston and just had snow blower crap out. Got it up and running pretty pain free thanks to this!
Spinner Guy: Thanks for the video. I used a combination of what you demonstrated and what some of the other people said in the comments. I have a Troy Built Storm 2 stage with dual belts and was able to change them out by removing the bottom cover along with the top cover.
rizzo777777: What is the belt part #?
David Rodriguez: Huge thanks for the video!
smwork2947: remove the friction wheel, this gives ample room to change auger belts WITHOUT SPLITTING MACHINE
John Law: Not necessary to split machine. This was a waste of time I can do in less than 10 min both belts
Tom Zirino: I have the same snow blower and the belts went do you have the model #of those napa belts..would be much appreciated..great video also
Dancedad: thank you so much very helpful
Jay So: I have changed my Auger belt twice and did not have to take it apart in half...its just not necessary
garyb2006: I changed all three belts. Auger turns, wheels don't. Any ideas on what I need to do to get this going and can it be done without draining gas and oil ?
lonestar22ful: Thanks a lot! Big help!:-)
Ron Bonnell: Thanks but I found a much easier way to do this. I couldn't get to that third bolt at the bottom because there isn't enough clearance. Mine is track driven. Called a repair guy. He said tip it up on the front of the blower. Remove the bottom plate, (4 3/8" screws), then just fish the belt through and walla you are finished. Worked like a charm. You still need to remove the belt cover, but not the tensioner. You need to hold down the drive and auger handles. I just bunged them.
Darryl M: Great vid....Made the idea of doing it myself a BREEZE !!! I'm left feeling with no doubt I can and will do it myself...... Thanks again !!!!!!!!!!
Wayne Stoegbauer: Excellent video, Right to the point, a big help. Isn't Wisconsin great.
RobiCuttingGuide: Thanks for the video. The wheelbarrow support was a help, but I wish there was more about the tensioner assembly removal and its reinstallation and adjustment.
semtech30: Thanks for your demo.
Mike Dooley: Excellent video. Have to get two belts for mine tomorrow. Also, nice to see another guy from Wisconsin fixing it. Thanks again...Mike from Pewaukee
How to change or replace your belts on your two stage mtd snowblower (The hard way?)5
out of 5